مرور دوره 2, شماره 3 بر اساس تاریخ انتشار

  • An approximate model for slug flow heat transfer in channels of arbitrary cross section 

    کلته, محمد؛ عباسی, عباس؛ بهرامی, مجید (دانشگاه صنعتی شاهرودShahrood University of Technology, 2012-09-22)
    In this paper, a novel approximate solution to determine the Nusselt number for thermally developed, slug (low-prandtl), laminar, single phase flow in channels of arbitrary cross section is presented. Using the Saint-Venant ...

  • On the natural convective heat transfer from a cold horizontal cylinder over an adiabatic surface 

    صداقت, محمد هادی؛ یعقوبی, محمود؛ مغربی, محمد جواد (دانشگاه صنعتی شاهرودShahrood University of Technology, 2012-09-22)
    A steady two-dimensional laminar free convection heat transfer from a cold horizontal isothermal cylinder located above an adiabatic floor is studied both experimentally and numerically. In the experimental measurements ...

  • Optimal intelligent control for glucose regulation 

    سیاهی, مهدی؛ الفی, علیرضا؛ نظری مریم آبادی, داوود؛ خوبان, محمدحسن (دانشگاه صنعتی شاهرودShahrood University of Technology, 2012-09-22)
    This paper introduces a novel control methodology based on fuzzy controller for a glucose-insulin regulatory system of type I diabetes patient. First, in order to incorporate knowledge about patient treatment, a fuzzy logic ...

  • A rule-based evaluation of ladder logic diagram and timed petri nets for programmable logic controllers 

    پویان, علی اکبر؛ مزینانیان, زینب؛ شمس, رضا (دانشگاه صنعتی شاهرودShahrood University of Technology, 2012-09-22)
    This paper describes an evaluation through a case study by measuring a rule-based approach, which proposed for ladder logic diagrams and Petri nets. In the beginning, programmable logic controllers were widely designed by ...

  • Optimal discrete-time control of robot manipulators in repetitive tasks 

    فاتح, محمد مهدی؛ بلوچ زاده, مریم (دانشگاه صنعتی شاهرودShahrood University of Technology, 2012-09-22)
    Optimal discrete-time control of linear systems has been presented already. There are some difficulties to design an optimal discrete-time control of robot manipulator since the robot manipulator is highly nonlinear and ...