Volume 2, Issue 2
مرور بر اساس
ارسال های اخیر
-
Experimental study of fracture mechanics in the aluminum matrix composites containing Fifteen percent silicon carbide particles
(Islamic Azad University, Khomeinishahr Branch, 2009-09-01)In this investigation ‚the fracture toughness of A356 containing15%SiC composite was studied. Al/SiC composites have been considered because of their mechanical and erosion properties .Low fracture toughness in Al/SiC as ...
-
Investigation of Porous Material Effects on Automotive Intake System Using Statistical Energy Analysis
(Islamic Azad University, Khomeinishahr Branch, 2009-09-01)Automobile manufactures are persistently trying to develop comfort of passengers by improving different specification such as decrease of sound level in engine compartments. There is a main problem that the noise generated ...
-
Analysis of Linear Two-Dimensional Equations by Hermitian Meshfree Collocation Method
(Islamic Azad University, Khomeinishahr Branch, 2009-09-01)Meshfree Collocation Method is used to solve linear two-dimensional problems. This method differs from weak form methods such as Galerkin method and no cellular networking and no numerical integration. Therefore, this ...
-
Tolerance Analysis of the Trigger Mechanism Assembly Using Direct Linearization Method
(Islamic Azad University, Khomeinishahr Branch, 2009-09-01)Tolerance analysis of mechanical assemblies is an important tool in reliable design of products at low cost and good quality. Using this tool, it is possible in manufacturing stage to observe the effect of parameters on ...
-
Investigation of Friction Coefficient Effects on Fishtail Defect in Hot Ring Rolling Process
(Islamic Azad University, Khomeinishahr Branch, 2009-09-01)Hot ring rolling is a highly nonlinear, unsteady-state and asymmetry process which is affected by many parameters. The friction coefficient between the ring ,the driver roll and the idle roll is one of the problems, which ...
-
Tolerance Analysis of the Trigger Mechanism Assembly Using Direct Linearization Method
(Islamic Azad University, Khomeinishahr Branch, 2009-09-01)Tolerance analysis of mechanical assemblies is an important tool in reliable design of products at low cost and good quality. Using this tool, it is possible in manufacturing stage to observe the effect of parameters on ...
-
An Upper Bound Solution for Analysis of Twist Extrusion Process with Elliptical Die Cross-section
(Islamic Azad University, Khomeinishahr Branch, 2009-09-01)Twist extrusion process is a rather new route to produce highly strained materials. In this process, severe plastic deformation is applied by large shear strains. In current article, required energy for twist extrusion by ...
