The elimination of the FexAly type phases was considered the solution to low ductility presented in aluminum-steel welded joints. Recently, the researches do not seek the suppression but the control ...

Potentially having a destructive influence on the mechanical properties of composite laminates, the invisible phenomenon of delamination frequently occurs under impact loading. In the present study, simulating the performance ...

In a shell and tube heat exchanger, the failure of tube-to-tubesheet welds results in high-pressure water jet which erodes the refractory in front of the tubesheet. Finite element method was employed to simulate the welding ...

Geometric imperfections such as radial imperfection, diamond shape, and local dimples could affect the buckling mode and load carrying capacity of axially compressed steel tubular columns. This paper experimentally ...

Piston aluminum alloys have different intermetallic phases, such as Cu3Al, Mg2Si ,and AlNi phases. The morphology and the distribution of such phases have important roles on mechanical properties of ...

In order to exhaustively exploit the high-level capabilities of shape memory alloys (SMAs), they must be applied in control systems applications. However, because of their hysteretic inherent, dilatory response, and nonlinear ...

Despite recent advances in face recognition systems, they suffer from serious problems because of the extensive types of changes in human face (changes like light, glasses, head tilt, different emotional modes). Each one ...

The interaction of work fluid mechanics with that of the rotary system itself, basically composed of axes, bearings and rotors, is performed by inserting equivalent dynamic coefficients in the mathematical model of the ...

Deformation of the silo wall due to the single ball impact is modeled in ANSYS. The material in silo, as a Winkler bed, is replaced by spring-damper elements and the spring stiffness and damper coefficients are evaluated ...

Dam construction is one of the challenges among large-scale projects of a country. Among different types of dams, due to special features, earth dams are the most kind of dams that were constructed in Iran in the past three ...

In this paper, a green transportation location problem is considered with uncertain demand parameter. Increasing robustness influences the number of trucks for sending goods and products, caused consequently, increase the ...

The recent penetration of renewable sources in the energy system caused a transformation of the needs of the distribution system and amplified the need of energy storage systems to properly balance the electricity grid. ...

Examining the cooling rate using impingement of air jet finds a wide application in electronic packaging and micro-scale fluid heat interaction systems, While the prediction of Nusselt profile at low nozzle-target spacing ...

In this study, granulated sludge synthesized in a sequence batch reactor (SBR) and then granulated sludge was transferred to continuous feeding and intermittent discharge (CFID) bioreactor. Two independent variables (air ...

This paper focuses on the problem of accurate Fault Characteristic Frequency (FCF) estimation of rolling bearing. Teager-Kaiser Energy Operator (TKEO) demodulation has been applied widely to rolling bearing fault detection. ...

Austenitic stainless steel SS304 grade was welded with active Tungsten Inert Gas (TIG) welding process by applying a flux paste made of SiO2 powder and acetone. SiO2 flux application improves the weld bead depth with a ...

56 ground motions of the bedrock and surface are selected from 28 stiff sites ( site class I and site classⅡ) of the KiK-net station．The peak acceleration, response spectra and shear strain of actual hard sites are calculated ...